Seal cracks, holes, and snapped metal without calling a plumber with a two-part repair putty you mix by hand, press into the damaged area, and let cure into a metal-tough plug that resists water, heat, and pressure.
Ithe putty has a thick, clay-like consistency that stays where you press it, filling gaps and holes rather than running away. Once cured, it can be sanded, drilled, and painted to resemble solid metal.
How to use: mix equal parts A and B, knead for about 20 seconds until the mixture becomes a uniform grey, then press firmly into the break. It begins to set in roughly 20–30 minutes and reaches full strength after 24 hours. The putty is packaged in a dual cartridge, 12.5 cm tall by 5 cm wide.
It bonds to steel, iron, aluminum, copper and more, so a single putty covers repairs across the toolbox. Once cured, you can sand, drill, or paint the repaired area to blend with the surrounding metal.
Compared with traditional glues, this two-part repair fills the damaged area rather than forming a film that can peel away. It stays waterproof and oil-resistant after curing and tolerates temperatures from -40°C to 200°C, making it suitable for pipes, radiators, and metal exposed to the elements.
After curing it behaves like solid metal — sandable, drillable, and paintable. Typical handling time is 20–30 minutes, with full cure at 24 hours.
In real-world use, installers report it holds on rusty or under-pressured joints and often eliminates the need for a service call. It can seal a leaking joint without shutting off water in some cases and is designed to endure water, heat up to 200°C, and pressure without backing down.
| Why IronHold | Generic Glues | Traditional Epoxy |
|---|---|---|
| Mixes thick — fills gaps & holes | ❌ Runs off, won't fill a gap | ❌ Often too runny, drips out |
| Holds -40°C to 200°C, waterproof once cured | ❌ | ❌ Weak in heat & moisture |
| Sandable, drillable, paintable like solid metal | ❌ Thin, brittle film | ❌ Inconsistent, can stay tacky |